Dahua Mobile DVR Series - Preset Setup

38
 Tour
 Pattern
 Border
Figure 4-25
In X330H330H330H300H300H300H307H X324H324H324H294H294H294H301HFigure 4-22, click page switch button, the interface is shown as in X331H331H331H301H301H301H308HFigure 4-26.
Here you can activate the following functions:
 Preset
 Tour
 Pattern
 Auto scan
 Auto pan
 Flip
 Reset
 Page switch
Figure 4-26
Note
 Preset, tour and pattern all need the value to be the control parameter. You can define it as
you require.
 You need to refer to your speed dome user’s manual for Aux definition. In some cases, it can
be used for special process.
 The following setups are usually operated in the X332H332H332H302H302H302H309HFigure 4-33,X333H333H333H303H303H303H310H Figure 4-36 and X334H334H334H304H304H304H311HFigure 4-37 .
4.6.1 Preset Setup
In X335H335H335H305H305H305H312H X324H324H324H294H294H294H301HFigure 4-22X, use eight direction arrows to adjust camera to the proper position.
In X336H336H336H306H306H306H313HFigure 4-26, click preset button and input preset number. The interface is shown as in X337H337H337H307H307H307H314HFigure
4-27X.
Now you can add this preset to one tour.