4.12.8 Register
This function allows the device to auto register to the proxy you specified. In this way, you can use
the client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In
the network service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the
auto register function, the device can auto register to the proxy server.
Step 1 From main menu->Setting->Network->Register, the setup interface is shown as in Figure
4-65.
Important
Do not input network default port such as TCP port number.
Figure 4-65
Step 2 The proxy server software developed from the SDK. Please open the software and input
the global setup. Please make sure the auto connection port here is the same as the port
you set in the previous step.
Step 3 Now you can add device. Please do not input default port number such as the TCP port
in the mapping port number. The device ID here shall be the same with the ID you input
in Figure 4-65. Click Add button to complete the setup.
Step 4 Now you can boot up the proxy server. When you see the network status is Y, it means
your registration is OK. You can view the proxy server when the device is online.
Important
The server IP address can also be domain. But you need to register a domain name
before you run proxy device server.
4.13 Account Manager
Here is to manage users, user group and authorities.
To Next Page
Loading...
