5 WEB OPERATION
There might be slightly difference in the interface due to different series.
Refer to the following sheet for commonly used button definition.
Click to restore default setup.
Click to save current setup.
Click to cancel current setup.
Click to copy current channel setup to other channel.
Click to refresh to get latest information.
5.1 Network Connection
Before web operation, please check the following items:
Network connection is right
DVR and PC network setup is right. Please refer to network setup(Setup ->Network)
Use order ping ***.***.***.***(DVR default IP address is 192.168.1.108) to check connection is
OK or not. Usually the return TTL value should be less than 255.
Open the IE and then input DVR IP address.
System can automatically download latest web control and the new version can overwrite the
previous one.
If you want to un-install the web control, please run uninstall webrec3.0.bat. Or you can go to
C:\Program Files\webrec to remove single folder. Please note, before you un-install, please
close all web pages, otherwise the un-installation might result in error.
5.2 Login
Step 1 Use a network cable to connect the device to the PC. The PC IP address is 192.168.1.***.
Step 2 Open browser and input DVR address in the address column. For example, if your DVR IP
is 192.168.1.108(default IP address), then please input http:// 192.168.1.108 in IE address
column and then click Enter button.
Step 3 System pops up warning information to ask you whether install control or not. Please click
Install button, system can auto run the installation. Or follow the prompts to save the
installation package and install. After installation, the interface is shown as below. See
Figure 5-1.
To Next Page
Loading...
