4.6.7 Auto Scan Setup
In X347H347H347H317H317H317H324HFigure 4-25, click border button. The interface is shown as in X348H348H348H318H318H318H325HFigure 4-30X.
Please go to Figure 4-22X, use direction arrows to select camera left limit
Then please go to X350H350H350H320H320H320H327HFigure 4-30 and click left limit button
Repeat the above procedures to set right limit.
Figure 4-30
4.6.8 Activate Auto Scan
In X351H351H351H321H321H321H328HFigure 4-26, click “Auto Scan” button, the system begins auto scan. Correspondingly, the auto
scan button becomes Stop button. Click stop button to terminate scan operation.
4.7 Aux function
In Figure 4-26, click Page switch button, you can see an interface is shown as below. See Figure
4-31. Here you can set auxiliary function. The aux value has relationship with the Aux button of
the decoder.
Figure 4-32
Click Page switch button, system goes to the following interface. The options here are defined by
the protocol. The aux number is corresponding to the aux on-off button of the decoder. See Figure
4-33.
To Next Page
Loading...
