Dahua Network Camera Web 3.0 - Page 105

Dahua Network Camera Web 3.0 Operation Manual
97
After the face database is successfully configured, it can realize comparison between the detected face
and the info in the face database.
Step 1
Select ‘Setting > Event > Face Recognition > Face Database Config” and the system will display the
interface of “Face Database Config”, which is shown in Figure 5-66.
Figure 5-66
Step 2
Click “Add Face” and the system will display the dialogue box of “Add Face Database”, which is shown
in Figure 5-67.
Figure 5-67
Step 3
Set the name of face database, click “OK”. The system will display the interface which is shown in
Figure 5-68.