Dahua Network Camera Web 3.0 - Record Control; System; General

Dahua Network Camera Web 3.0 Operation Manual
122
5.4.3 Record control
The record control interface is shown as in Figure 5-105.
Figure 5-105
Please refer to the following sheet for detailed information.
Parameter
Function
Pack
Duration
Here you can select file size within 1min~120min. Default setup is 8
minutes.
Pre-record
Please input pre-record value here.
For example, system can record the four seconds video in the buffer.
The record begins from the fifth second.
Note:
Configure pre-record time, when alarm or motion detection occurs, if
there is no record, system will record the preceding n seconds
record.
Disk Full
There are two options: stop recording or overwrite the previous files
when HDD is full.
 Stop: Current working HDD is overwriting or current HDD is full,
it will stop record.
 Overwrite: Current working HDD is full; it will overwrite the
previous file.
Record
mode
There are three modes: Auto/manual/close.
Record
stream
There are two options: main stream and sub stream.
5.5 System
5.5.1 General
The General interface is shown as in Figure 5-106.