Dahua Network Camera Web 3.0 User Manual

Dahua Network Camera Web 3.0 Operation Manual
109
It is to set begin time and end time.
Step 3
Click “Search” to complete report statistics, click “Export” to export the statistics report.
5.3.8 Alarm
Please note some series products do not support this function.
5.3.2.1 PIR alarm
The alarm activation interface PIR alarm is shown as in Figure 5-85.
Figure 5-85
Please refer to the following sheet for detailed information.
Parameter
Function
Enable
After enabled, relay activation will work. Check it and enable the
PIR alarm.
Working
period
 This function becomes activated in the specified periods.
 There are six periods in one day. Please draw a circle to
enable corresponding period.
 Select date. If you do not select, current setup applies to
today only. You can select all week column to apply to the
whole week.
 Click OK button, system goes back to motion detection
interface; please click save button to exit.
Note: User can set via dragging mouse while not releasing left
mouse.
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 0s to 100s.

Dahua Network Camera Web 3.0 Specifications

General

Brand	Dahua
Model	Network Camera Web 3.0
Category	Security Camera
Language	English