For user name and user group, the max length is 31 characters, which can be made up of digit,
letter, underline, hyphen, dot and @.
Password can be 0~32 characters in number and letter only. User can modify other user’s
password.
User and group can be manually added to 18 and 8 respectively.
User management adopts group/user modes. The user name and the group name shall be unique.
One user shall be included in only one group.
Currently logged in user cannot change his/her own right.
5.5.2.1 Username
In this interface you can enable anonymity login, add/remove user and modify user name. See Figure
5-108.
Figure 5-108
Enable anonymity login: Enable anonymity login, and input IP. No username or password is required,
you can log in by anonymity (with limited rights). You can click logout to end your session.
Add user: It is to add a name to group and set the user rights. See Figure 5-86.
Hidden user “default” is for system interior use only and cannot be deleted. When there is no login user,
hidden user “default” automatically login. You can set some rights such as monitor for this user so that
you can view some channel view without login.
Here you can input the user name and password and then select one group for current user.
Please note the user rights shall not exceed the group right setup.
For convenient setup, please make sure the general user has the lower rights setup than the admin.
To Next Page
Loading...
Need help?
General
