Dahua Network Camera Web 3.0 - Page 37

Dahua Network Camera Web 3.0 Operation Manual
29
Click “Save” and complete the image parameter config of the camera.
5.1.1.2 Exposure
Step 1
Select “Setup > Camera > Conditions > Exposure”. The system will display the “Exposure” interface
which is shown in Figure 5-2.
Figure 5-2
Step 2
It is to set the exposure parameter, please refer to the following sheet for more details.
Parameter
Note
Anti-flicker
 You can switch to exposure mode when it is in outdoor
mode, it can realize the result in the corresponding exposure
mode.
 50Hz: When the current is 50Hz, system can auto adjust the
exposure according to the environment brightness in case
there is any stripe.
 60Hz: When the current is 60Hz, system can auto adjust the
exposure according to the environment brightness in case
there is any stripe.