Dahua Network Camera Web 3.0 - Page 42

Dahua Network Camera Web 3.0 Operation Manual
34
Select “Setup > Camera > Conditions > Day & Night” and the system will display the interface of “Day &
Night”, which is shown in Figure 5-5.
Figure 5-5
Step 2
Set day & night parameter; please refer to the following sheet for more details.
Parameter
Note
Mode
It is to set the camera image displayed as color or black & white mode.
Note:
The setting of “Day/Night Mode” is not affected by the setting of “Profile
Management”.
It includes the following options:
 Color: The camera image is displayed as color image.
 Auto: The camera can auto select color image or black & white image
to be displayed according to the environmental brightness.
 Black & white: The camera image is displayed as black & white image.
Sensitivity
The parameter can be set when the “Day/Night Mode” is “Auto”.
It is to set the sensitivity of the switch between image color display and
black & white display.
Delay
The parameter can be set when the “Day/Night Mode” is “Auto”.
It is to set the switch delay between image color display and white & black
display. The smaller the delay is, the faster of the switch becomes between
color display and black & white display.
Step 3
Click “Save” to complete the config of day/night mode.
5.1.1.6 Defog