Figure 5-52
2. Select signed certificate and certificate key path respectively via “Browse”, click “Upload”.
3. Install root certificate, please refer to step 6~11 for more details.
4. Check “Enable HTTPs”, click “Save”. The system will display the dialog box of “Need to reboot the
device”, and then the config is valid.
Figure 5-53
5. Use HTTPs
Use HTTPs to log in.
Enter https://xx.xx.xx.xx in the browser, and it will pop out normal login interface; the browser will prompt
certificate error if the certificate is not installed, which is shown in Figure 5-54.
To Next Page
Loading...
