332
Figure 4-108
Figure 4-109
Please refer to the following sheet for detailed information.
Parameter
Function
Event
Type
The HDD event type includes: No HDD, HDD error, no space.
Figure 4-107.
You can set one or more items here.
Less than: You can set the minimum percentage value here (For HDD
not space only). The device can alarm when capacity is not sufficient.
You need to draw a circle to enable this function.
Network event type includes: Disconnect/IP conflict/MAC conflict.
See Figure 4-108.
Power fault. The interface is shown as in Figure 4-109
is for power-
redundancy series product. When this function is on,
you can remove one power sourcing from the system, it does not
a
ffect the normal operation of the device, but system will generate
alarm to alert you.
Enable Check the box here to enable selected function.
To Next Page
Loading...
