Dahua NVR608-32-4KS2 - Page 350

334
Figure 4-111
Click Add, you can see the following dialogue box. See Figure 4-112.
Figure 4-112
Check the box to enable POS function, Click Set button; you can see the following interface. See Figure
4-113
Figure 4-113
Set source IP and destination IP, and then click OK. System goes back to Figure 4-112.
 Source IP: POS device IP address.
 Destination IP: NVR IP address.
In Figure 4-112, click Channel Set button, select the channel you want to overlay POS information. Click
OK button to complete the setup.
Tips
: Click it to delete POS setup.
: Click it to change setup information.