Interface Operation 39
You can only customize 10 ring tones. Other ring tones will not be displayed at the VTH.
6.2.1.1 VTO Ring
Set a ring for the connected VTO, and support to set maximum 20 VTOs.
Press [Setting]. Step 1
The system pops up “Password” prompt box.
Input login password and press [OK]. Step 2
Default login password is 123456. Please refer to “6.2.6.3 Password Setting“ for
details.
Select “Ring > VTO Ring Setup”. Step 3
The system displays “VTO Ring Setup” interface, as shown in Figure 6-2. Press
or to page up and down.
Figure 6-2
Press text box to select rings, and press and to set the volume. Step 4
6.2.1.2 VTH Ring
Set the ring of this VTH.
Press [Setting]. Step 1
The system pops up “Password” prompt box.
Input login password and press [OK]. Step 2
Default login password is 123456. Please refer to “6.2.6.3 Password Setting“ for
details.
To Next Page
Loading...
Need help?
General
