Page 50 of 60 IM 817-4
To avoid electrical shock, personal injury or death, be sure that eld
wiring complies with local and national re, safety, and electrical
codes, and voltage to the system is within the limits shown in the
job-specic drawings and unit electrical data plate(s). Power supply
to unit must be disconnected when making eld connections.
Rigorously adhere to eld wiring procedures regarding proper
lockout and tagout of components.
Electric Heating
Table 30 - Standard Motor Electric Heat Capacities, Amps, Wire Sizing, and Over Current Protection
# Amps at unit voltage, 60Hz, single phase
Note: Unit wire sizing should be determined in accordance with NEC and local codes.
* External static pressure ranges must be strictly adhered to.
WARNING
To Next Page
Loading...
