SiENBE04-808_A Indoor Unit
Removal Procedure 172
2
Lift up the bottom of the
control PCB and pull it
out.
When mounting the control
PCB, make sure that it is
fixed by upper 2 hooks.
3
The figures show the
names of the PCB
component parts.
[S1]: DC fan motor
[S21]: HA connector
[S25]: INTELLIGENT EYE
sensor PCB
[S26]: control PCB
[S32]: indoor heat exchanger
thermistor
[S41]: swing motors
[S46]: display PCB
[S47]: signal receiver PCB
[S48] [S49]: control PCB
Refer to page 19, 20 for
detail.
Step Procedure Points
(R8098)
(R8099)
[S32]
[S1]
[S21]
[S47]
[S25]
[S46]
[S41]
(R8100)
[S48]
[S49]
[S26]
LED2
(Yellow)
LED3
(Green)
LED1
(Green)
To Next Page
Loading...
