Danfoss ECL COMFORT - Basic set-up; Cut-in and cut-out temperature at DHW charging - lines 1-2, circuit II

The grey
side of the
ECL Card
Basic set-up
Shift to manual mode.
Controlled units
5
1 2
036
B
3
ON
1
ON
2
ON
Controller mode
Choose the unit you want to control. The selected
unit symbol will blink.
Controlled units are switched OFF or ON when
the relevant button is pushed.
The motorized actuator (gear motor /
damper)
closes or opens the controlled unit as long as
the relevant button is pushed. If pushed for more
than 3 seconds, the actuator continues to close or
open the valve.
The thermo actuator
activates the valve as long as the button is
pushed. If pushed for more than 3 seconds, the
actuator continues to open the valve.
Check the activation direction of the actuator either by
looking at it or by feeling whether the temperature of the
actual pipe changes as expected.
This operation applies to both circuits, if available.
During manual operation, all control functions are deactivated.
Manual control -
line B
19