Symptom Possible cause Test Solution
Acoustic noise or vibration
(e.g. a fan blade is making
noise or vibrations at
certain frequencies)
Resonances, e.g. in the motor/fan
system
Bypass critical frequencies by using
parameters in parameter group
4-6* Speed Bypass
Check if noise and/or vibration
have been reduced to an
acceptable limit
Turn off over-modulation in
14-03 Overmodulation
Change switching pattern and
frequency in parameter group
14-0* Inverter Switching
Increase Resonance Dampening in
1-64 Resonance Damping
Table 10.1 Troubleshooting
Basic Troubleshooting Operating Instructions
MG16D302 Danfoss A/S © Rev. 06/2014 All rights reserved. 75
10 10
To Next Page
Loading...
Need help?
General