Danfoss FC 102 User Manual

1 Introduction
1.1 Purpose of the Manual
This operating guide provides information for safe instal-
lation and commissioning of the VLT
®
drives in an
enclosure size E (E1h, E2h, E3h, and E4h).
The operating guide is intended for use by qualied
personnel. To use the unit safely and professionally, read
and follow this operating guide. Pay particular attention to
the safety instructions and general warnings. Always keep
the operating guide with the drive.
VLT
®
is a registered trademark.
1.2 Additional Resources
Other resources are available to understand advanced E1h–
E4h drive functions and programming.
•
The VLT
®
HVAC Drive FC 102 Programming Guide
provides greater detail on working with
parameters and HVAC application examples.
•
The VLT
®
HVAC Drive FC 102, 90–1200 kW Design
Guide provides detailed capabilities and
functionality to design motor control systems for
HVAC applications.
•
The Safe Torque O Operating Guide provides
detailed specications, requirements, and instal-
lation instructions for the Safe Torque O
function.
Supplementary publications and manuals are available
from Danfoss. See drives.danfoss.com/knowledge-center/
technical-documentation/ for listings.
1.3
Manual and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the version of the manual and the corresponding software
version.
Manual version Remarks Software version
MG16O1xx Initial release 4.44
Table 1.1 Manual and Software Version
1.4
Approvals and Certications
Table 1.2 Approvals and
Certications
More approvals and certications are available. Contact the
local Danfoss oce or partner. Drives of voltage T7 (525–
690 V) are UL certied for only 525–600 V.
The drive complies with UL 61800-5-1 thermal memory
retention requirements. For more information, refer to the
section Motor Thermal Protection in the product-specic
design guide.
NOTICE
IMPOSED LIMITATIONS ON THE OUTPUT
FREQUENCY
From software version 3.92, the output frequency of the
drive is limited to 590 Hz due to export control
regulations.
1.4.1 Compliance with ADN
For compliance with the European Agreement concerning
International Carriage of Dangerous Goods by Inland
Waterways (ADN), refer to ADN-compliant Installation in the
design guide.
1.5
Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Introduction Operating Guide
MG16O102 Danfoss A/S © 01/2017 All rights reserved. 3
1 1

Danfoss FC 102 Specifications

General

Brand	Danfoss
Model	FC 102
Category	DC Drives
Language	English