WARNING
EQUIPMENT HAZARD
Contact with rotating shafts and electrical equipment
can result in death or serious injury.
•
Ensure that only trained and qualied personnel
install, start up, and maintain the drive.
•
Ensure that electrical work conforms to national
and local electrical codes.
•
Follow the procedures in this guide.
CAUTION
HOT SURFACES
The drive contains metal components that are still hot
even after the drive has been powered o. Failure to
observe the high temperature symbol (yellow triangle)
on the drive can result in serious burns.
•
Be aware that internal components, such as
busbars, may be extremely hot even after the
drive has been powered o.
•
Exterior areas marked by the high temperature
symbol (yellow triangle) are hot while the drive
is in use and immediately after being powered
o.
WARNING
INTERNAL FAILURE HAZARD
Under certain circumstances, an internal failure can
cause a component to explode. Failure to keep the
enclosure closed and properly secured can cause death
or serious injury.
•
Do not operate the drive with the door open or
panels o.
•
Ensure that the enclosure is properly closed and
secured during operation.
NOTICE
MAINS SHIELD SAFETY OPTION
A mains shield option is available for enclosures with a
protection rating of IP21/IP 54 (Type 1/Type 12). The
mains shield is a Lexan cover installed inside the
enclosure to protect against the accidental touch of the
power terminals, according to BGV A2, VBG 4.
Safety Operating Guide
MG16O102 Danfoss A/S © 01/2017 All rights reserved. 5
2 2
To Next Page
Loading...
Need help?
General