Danfoss VACON 1000 User Manual

Standard number
Standard Name
IEC 60721-3-3
Classification of environmental conditions - Part 3-3: Classification of groups of environmental parame-
ters and their severities - Stationary use at weather protected locations
IEC 61000-2-1:1990
Electromagnetic compatibility (EMC) - Part 2: Environment - Section 1: Description of the environment -
Electromagnetic environment for low-frequency conducted disturbances and signaling in public pow-
er supply systems (Immunity only)
IEC 61000-2-4
Electromagnetic compatibility (EMC) - Part 2-4: Environment - Compatibility levels in industrial plants
for low-frequency conducted disturbances
EN 61000-4-2:2009
Electromagnetic compatibility (EMC). Testing and measurement techniques. Electrostatic discharge im-
munity test (Immunity only)
EN 61000-4-4:2004
+A1:2010
Electromagnetic compatibility (EMC). Testing and measurement techniques. Electrical fast transient/
burst immunity test (Immunity only)
EN 61000-4-5:2006
Electromagnetic compatibility (EMC). Testing and measurement techniques. Surge immunity test (Im-
munity only)
EN 61000-4-6:2009
Electromagnetic compatibility (EMC). Testing and measurement techniques. Immunity to conducted
disturbances, induced by radio-frequency fields (Immunity only)
IEC 61000-4-7:2002
+AMD1:2008 CSV
Electromagnetic compatibility (EMC) – Part 4-7: Testing and measurement techniques – General guide
on harmonics and inter-harmonics measurements and instrumentation, for power supply systems and
equipment connected thereto
EN 61000-4-8:2010
Electromagnetic compatibility (EMC). Testing and measurement techniques. Power frequency magnet-
ic field immunity test (Immunity only)
EN 61000-4-11:2004
Electromagnetic compatibility (EMC). Testing and measurement techniques. Voltage dips, short inter-
ruptions and voltage variations immunity tests (Immunity only)
IEC 61000-2-5:2017 RLV
Electromagnetic compatibility (EMC) – Part 2-5: Environment – Description and classification of electro-
magnetic environments
IEC 61800-3
Adjustable speed electrical power drive systems - Part 3: EMC requirements and specific test methods
IEC 61800-4
Adjustable speed electrical power drive systems - Part 4: General requirements - Rating specifications
for a.c. power drive systems above 1000 V a.c. and not exceeding 35 kV
IEC 61800-5-1
Adjustable speed electrical power drive systems - Part 5-1: Safety requirements - Electrical , thermal
and energy
IEC61800-9-2
Adjustable speed electrical power drive systems - Part 9-2: Ecodesign for power drive systems, motor
starters, power electronics and their driven applications-Energy efficiency indicators for power drive
systems and motor starters
ISO/EN 12944-2
Paints and varnishes- corrosion protection of steel structures by protective paint system – Part 2: Classi-
fication of environments
GR-63, Issue 4:2012
NEBS Requirements: Physical Protection
NR-10
Safety in electrical Installations and Services
NEMA MG 1-2016
Motors and Generators: Part 30 Application Considerations for Constant Speed Motors Used on a Si-
nusoidal Bus with Harmonic Content and General Purpose Motors Used With Adjustable-Voltage or
Adjustable-Frequency Controls or Both
ASCE/SEI 7-10
Minimum Design Loads for Buildings and Other Structures
AQ363633621020en-000201 / 172F3117 | 139Danfoss A/S © 2021.06
Specifications
VACON® 1000
Operating Guide

Danfoss VACON 1000 Specifications

General

Brand	Danfoss
Model	VACON 1000
Category	Media Converter
Language	English