Semiconductor convertors – General requirements and line commutated convertors – Part 1-3: Trans-
formers and reactors
Semiconductor converters - Part 2: Self-commutated semiconductor converters including direct d.c.
converters
Safety of machinery – Electrical equipment of machines – Part 11: Requirements for HV equipment for
voltages above 1000 V a.c. or 1500 V d.c. and not exceeding 36 kV
IEC 60529:1989
+AMD1:1999
+AMD2:2013 CSV
Degrees of protection provided by enclosures (IP Code)
Classification of environmental conditions – Part 3 Classification of groups of environmental parame-
ters and their severities – Section 1: Storage
Classification of environmental conditions – Part 3: Classification of groups of environmental parame-
ters and their severities – Section 2: transportation vibration random, free fall and shock-packaged
IEC 60721-3-3:1994
+AMD1:1995
+AMD2:1996 CSV
Classification of environmental conditions – Part 3-3: Classification of groups of environmental param-
eters and their severities – Stationary use at weather protected locations
Code for designation of colors
IEC 60947-5-5:1997
+AMD1:2005
+AMD2:2016 CSV
Low-voltage switchgear and controlgear – Part 5-5: Control circuit devices and switching elements –
Electrical emergency stop device with mechanical latching function
Power transformers - Part 1: General
Power transformers - Part 11: Dry-type transformers
Power transformers - Part 12: Loading guide for dry-type power transformers
Power transformers - Part 2: Temperature rise
Power transformers - Part 3: Insulation levels, dielectric tests and external clearances in air
Converter transformers – Part 1: Transformers for industrial applications
Converter transformers – Part 3: Application guide
Transformers, Distribution, Dry-Type – Over 600 Volts
General Requirements for Dry-Type Distribution and Power Transformers
Test Procedure for Thermal Evaluation of Insulation Systems for Dry-Type Power and Distribution
Transformers, Including Open-Wound, Solid-Cast, and Resin-Encapsulated Transformers
IEEE Standard Test Code for Dry-Type Distribution and Power Transformers
Draft Guide for Conducting a Transient Voltage Analysis of a Dry-Type Transformer Coil
Detection of Partial Discharge and the Measurement of Apparent Charge in Dry-Type Transformers.
Classification of environmental conditions - Part 3 Classification of groups of environmental parame-
ters and their severities - Section 1: Storage
Classification of environmental conditions - Part 3: Classification of groups of environmental parame-
ters and their severities - Section 2: Transportation
AQ363633621020en-000201 / 172F3117138 | Danfoss A/S © 2021.06
Specifications
VACON® 1000
Operating Guide
To Next Page
Loading...
Need help?
General
