Danfoss VLT AQUA Drive FC 202 Operating Instructions

0-39 Display Text 3
Range: Function:
0 N/A* [0 - 0 N/A] In this parameter it is possible to write an individual text string for display in the LCP or to be read
via serial communication. If to be displayed permanently select Display Text 3 in par. 0-20 Dis-
play
Line 1.1 Small ,par. 0-21 Display Line 1.2 Small , par. 0-22 Display Line 1.3 Small , par.
0-23 Display
Line 2 Large or par. 0-24 Display Line 3 Large . Use the
▲
or
▼
buttons on the LCP to
change a character. Use the
◀
and
▶
buttons to move the cursor. When a character is highlighted
by the cursor, this character can be changed. A character can be inserted by placing the cursor
between two characters and pressing
▲
or
▼
.
0-70 Set Date and Time
Range: Function:
2000-01-01
00:00 –
2099-12-01
23:59 *
[2000-01-01 00:00] Sets the date and time of the internal clock. The format to be used is set in par. 0-71 and 0-72.
NB!
This parameter does not display the actual time. This can be read in par. 0-89.
The clock will not begin counting until a setting different from default has been
made.
0-71 Date Format
Option: Function:
[0] * YYYY-MM-DD Sets the date format to be used in the LCP.
[1] DD-MM-YYYY Sets the date format to be used in the LCP.
[2] MM/DD/YYYY Sets the date format to be used in the LCP.
0-72 Time Format
Option: Function:
Sets the time format to be used in the LCP.
[0] * 24 h
[1] 12 h
0-74 DST/Summertime
Option: Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime
enter the start date and end date in par. 0-76
DST/Summertime Start and par. 0-77 DST/Summer-
time End
.
[0] * Off
[2] Manual
0-76 DST/Summertime Start
Range: Function:
0 N/A* [0 - 0 N/A] Sets the date and time when summertime/DST starts. The date is programmed in the format se-
lected in par. 0-71 Date
Format .
0-77 DST/Summertime End
Range: Function:
0 N/A* [0 - 0 N/A] Sets the date and time when summertime/DST ends. The date is programmed in the format selected
in par. 0-71 Date
Format .
8.2.3. General Settings, 1-0*
Define whether the frequency converter operates in open loop or closed loop.
8. How to programme the frequency converter
VLT
®
AQUA Drive
Operating Instructions
74 MG.20.M5.02 - VLT
®
is a registered Danfoss trademark
8

Danfoss VLT AQUA Drive FC 202 Specifications

General

Brand	Danfoss
Model	VLT AQUA Drive FC 202
Category	DC Drives
Language	English