Danfoss VLT AutomationDrive FC 300 - Terminal Locations - Frame Size E9

4.3.4 Terminal Locations - Frame Size E9
Take the following position of the terminals into consid-
eration when designing the cable access.
130BB431.10
332.5
[13.1]
.0
[.0]
.0 [.0]
.0 [.0]
407.5 [16.0] 332.0 [13.1]
88.0 [3.5]
168.0 [6.6]
Illustration 4.13 Terminal locations Mains Cables
Section shown
↓
Table 4.5
FASTENER TORQUE
FASTENER TORQUE
-R 81 +R 82
M8 9.6 NM (7 FT-LB)
FASTENER TORQUE M8 9.6 NM (7 FT-LB)
19 Nm (14 FT-LB)
M10 19 N
W/T3 98
W/T2 97
U/T1 96
458,1
[18.0]
322,5
[12.7]
,0
[.0]
,0 [.0] ,0 [.0]
527,7 [20.8] 525,0 ]20.7] 443,7 [17.5] 412,5 [16.2] 300,0 [11.8] 187,5 [7.4]
75,0 [3.0] 280,2 [11.0] 153,9 [6.1]
130BB432.10
Illustration 4.13 Terminal locations motor cables
Section shown
↓
Table 4.6
How to Install VLT Automation Low Harmonic Drive Operating Instructions
MG34O202 - VLT
®
is a registered Danfoss trademark 23
4 4