Danfoss VLT AutomationDrive FC 361 Programming Guide

15-50 SW ID Power Card
Range: Function:
0* [0 - 20 ] View the power card software
version number.
15-51 Frequency Converter Serial Number
Range: Function:
0* [0 - 10 ] View the frequency converter serial
number.
15-53 Power Card Serial Number
Range: Function:
0* [0 - 19 ] View the power card serial number.
15-54 Cong File Name
Array [5]
Range: Function:
Size
related*
[0 - 16] Shows the special conguration
lenames.
15-59 Filename
Range: Function:
Size
related*
[0 - 16] Shows the currently used customer-
specic initial values (CSIV)
lename.
4.14.6 15-6* Option Ident.
This read-only parameter group contains information about
the hardware and software conguration of the options
installed in slots A, B, C0, and C1.
15-60 Option Mounted
Array [8]
Range: Function:
0* [0 - 30 ] Shows the type of the installed
option.
15-61 Option SW Version
Array [8]
Range: Function:
0* [0 - 20 ] View the installed option software
version.
15-62 Option Ordering No
Array [8]
Range: Function:
0* [0 - 8 ] Shows the ordering number for the
installed options.
15-63 Option Serial No
Array [8]
Range: Function:
0* [0 - 18 ] View the installed option serial
number.
4.14.7 15-8* Operating Data II
15-80 Fan Running Hours
Range: Function:
0 h* [0 -
2147483647 h]
View how many hours the heat sink
fan has run (increments for every
hour). The value is saved when the
frequency converter is turned o.
15-81 Preset Fan Running Hours
Range: Function:
0 h* [0 - 99999 h] Enter the preset fan running hours
counter, see parameter 15-80 Fan
Running Hours.
This parameter cannot be selected
via the serial port, RS485.
4.14.8 15-9* Parameter Info
15-92 Dened Parameters
Range: Function:
0* [0 - 9999 ] View a list of all dened parameters
in the frequency converter. The list
ends with 0.
15-93 Modied Parameters
Range: Function:
0* [0 - 9999 ] View a list of the parameters that
have been changed from their
default setting. The list ends with 0.
Changes may not be visible until
up to 30 s after implementation.
4.15 Parameters: 16-** Data Readouts
4.15.1 16-0* General Status
16-00 Control Word
Range: Function:
0* [0 - 65535 ] View the control word sent from
the frequency converter via the
serial communication port in hex
code.
Parameter Descriptions Programming Guide
MG06J202 Danfoss A/S © 03/2019 All rights reserved. 143
4 4

Danfoss VLT AutomationDrive FC 361 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 361
Category	DC Drives
Language	English