Danfoss VLT Safety Option MCB 150 - Safety Option Customization

• Feasibility of the configuration data.
• Proper wiring.
• Correct device number (ordering number). If the self-test is successful, the power element of the drive is enabled.
NOTICE
Up to 10 s may elapse before the safety option is ready for operation.
5.2.3 Safety Option Customization
The following LCP messages indicate the different states of the customization process.
LCP message Description
e30bd125.11
Status
SO C us tom. requested
!1(1)
0 R PM None 0.00 KW
!Safe Stop [W68]
MCT 10 customization of the safety option is requested.
e30bd124.11
Status
SO Custom. aborted
SO RESET required!
!1(1)
0 RPM None 0.00KW
!Safe Stop [W68]
Off Remote SO Req.RESET
MCT 10 customization of the safety option is aborted.
e30bd122.11
Status
SO Custom. completed
SO RESET required!
!1(1)
0 RPM None 0.00KW
!Safe Stop [W68]
Off Remote SO Req.RESET
MCT 10 customization of the safety option is complete.
Commissioning
Installation Guide | VLT® Safety Option MCB 150/151
AQ279747441421en-000101 / 130R0292
54 | Danfoss A/S © 2018.09