Danfoss VLT series User Manual

Contents
1 Introduction
4
1.1 Purpose of the Manual
4
1.2 Additional Resources
4
1.3 Document and Software Version
4
1.4 Approvals and Certications
4
1.5 Disposal
5
1.6 Abbreviations and Conventions
5
2 Safety Instructions
7
2.1 Safety Symbols
7
2.2 Qualied Personnel
7
2.3 Safety Regulations
7
3 How to Install
9
3.1 Pre-installation
9
3.1.1 Planning the Installation Site 9
3.1.1.1 Inspection on Receipt 9
3.1.2 Transportation and Unpacking 9
3.1.3 Lifting Unit 9
3.1.4 Mechanical Dimensions 12
3.2 Mechanical Installation
18
3.2.1 Preparation for Installation 18
3.2.2 Tools Required 18
3.2.3 General Considerations 18
3.2.4 Terminal Locations, F8–F15 20
3.2.4.1 Inverter and Rectier, Enclosure Sizes F8, and F9 20
3.2.4.2 Inverter, Enclosure Sizes F10 and F11 21
3.2.4.3 Inverter, Enclosure Sizes F12 and F13 22
3.2.4.4 Inverter, Enclosure Sizes F14 and F15 23
3.2.4.5 Rectier, Enclosure Sizes F10, F11, F12, and F13 24
3.2.4.6 Rectier, Enclosure Sizes F14 and F15 25
3.2.4.7 Options Cabinet, Enclosure Size F9 26
3.2.4.8 Options Cabinet, Enclosure Sizes F11 and F13 27
3.2.4.9 Options Cabinet, Enclosure Size F15 28
3.2.5 Cooling and Airow 28
3.3 Installing the Panel Options
34
3.3.1 Panel Options 34
3.4 Electrical Installation
35
3.4.1 Transformer Selection 36
3.4.2 Power Connections 36
Contents Operating Instructions
MG34Q402 Danfoss A/S © 04/2016 All rights reserved. 1

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)