Danfysik 9700 - Page 25

System 9700 User Manual
Page 25 of 56
3.3.1.1. UART HW SET UP (Esc<BAUD)
In “UART HW SETUP” mode, the baud rate and associated parameters for the serial lines can
be set.
SW3 indicates which line to set up.
HINT
Selecting SW3 will immediately display the present setting on the red LEDs below SW4.
SW3 FOR LOCAL LINE
SW3 FOR REMOTE LINE
ON ON
1
2 3
4
1
2
3
4
4
1
Parameters
PARITY
7 / 8 Bits
8 Bits
1½
2
7 Bits
STOP Bits
OFF
OFF
ON
ODD/EVEN
EVEN
ODD
BAUD
RATE
ON
1.200 2.400
9.600 19.200 38.400
57.600 76.800 115.200
1 2
3
4 5 6 7 8
SW4
Default setting after “COLD BOOT”:
 Local Line: 9600Baud, No parity, 8 Bits, 2 Stop bits.
 Remote Line: 115200Baud, No parity, 8 Bits, 1 Stop bit.