Danfysik 9700 - Page 43

System 9700 User Manual
Page 43 of 56
3.3.5.4. SW limits
The limits of the “Arbitrary point method” ramp profile SW are:
 The set value must be given in ppm units.
 The time between two points can be between 0.2 to 65535 seconds.
 Maximum numbers of stacks: = 15
 Maximum number of lines in a stack: = 15
The limits of the “Equal time slot method” ramp profile SW are:
 The set value must be given in a floating point representation normalized to 1.000000.
 The time slot may be between 0.0125 to 1 second given in a floating point representation
normalized to 1.0000.
 Maximum numbers of stacks = 1
 Maximum number of time slots in a stack = 1000
The limits of the “Auto Slew Rate method” ramp profile SW are:
 Maximum positive slew rate time = 10 sec,
 Maximum negative slew rate time = 10 sec,
 Minimum positive slew rate time = 5 ms,
 Minimum negative slew rate time = 5 ms,
 Number of points = 80 with a minimum interval of 1.25ms