EASYSENSE Q3+ and Q5+ DO185 (2)
•
If you wish to alter the choice use the blue buttons to scroll the pointer until it is
pointing at the preferred language, which will automatically employ.
Specifications
4 x 20 Character LCD Display
Firmware upgradeable
USB compatible communication V1.1 & V2.0 compatible
Operating range: 0 - 40°C and 0 to 95%RH (non-condensing).
Memory Capacity: 8 data sets
10 bit sampling resolution
Note: Smart Q Sensors are capable of 12 bit resolution. Specifications stated for Smart Q Sensors
are applicable when used with a 12 bit data logger or interface e.g. EASYSENSE Q Advanced.
EASYSENSE Q3 or 5+ are 10 bit data loggers so may not be able to fully utilise this capability
and the resolution stated for each Sensor may not be as high.
Graph maximum logging speed:
Q3+ = 20 millisecond (ms) interval between samples
Q5+ = 1 millisecond (ms) interval between samples
Scope maximum logging speed:
Q3+ = 20 millisecond (ms) interval
Q5+ USB communication = 1 millisecond (ms) interval
Q5+ Bluetooth communication = 20 ms (millisecond) interval
Digital timing: Resolution = 4 microseconds, accurate to 5 decimal places
Power supply specifications: 5V DC mains adaptor, able to supply 500 to 1000 mA,
with a positive centre and negative outer pin.
Bluetooth functionality (if fitted):
Compatible with a Bluetooth V1.1 or later devices
Operating range: 10 metre (33 Feet) radius indoors
Care & Maintenance
• Clean with a damp cloth, do not immerse in water or detergent. EASYSENSE Q is
not waterproof.
• EASYSENSE Q is suitable for use in an operating range of 0 - 40°C and 0 to
95%RH (non-condensing).
• Do not subject to extreme heat or cold or leave in a location where it will get wet.
• If EASYSENSE Q has been left in the cold, let it warm to near room temperature
before waking it from sleep.
• Do not expose to direct sunlight for extended periods of time.
• Do not expose to temperatures greater than 60˚ C, e.g. near a heater or inside a car
in hot weather.
• Do not store EASYSENSE Q with its battery fully discharged. Ideally
EASYSENSE Q should be stored at least 40% or more state-of-charge. See page
26.
© Data Harvest Group Ltd.
28
To Next Page
Loading...
