DataCard SD260 - Bolt-Down Option

A-4 SD460 Laminating System
Bolt-Down Option
Thelaminatorincludesbolt‐downopeningsthatyoucanusetosecurethesystem
toamountingsurface.
Youneedthefollowingsupplies:
• Thebolt‐downkit(partno.509169‐001)containstwoM6wellnuts.
• TwoM6(6mm)screws,purchasedseparately.
Thelengthofthescrewsyouneeddependsonthethicknessofthemounting
surface.Thescrewlengthisthesurfacethickness+0.75inch(20mm).
• TwoM6washers,purchasedseparately.
• 1/4‐inch(7mm)drillbit.
1. Drilltwoholesinthemountingsurfacefollowingthedimensionsand
requirementsshowninthefollowingfigure :

Thisprocedureisoptional.