DataCard SD260 - Page 110

A-10 SD460 Laminating System
5. Loadthenewrolloflaminator
overlaymaterial.
A. Putthebluesupplyspoolon
thebluesupplyspindle ofthe
cartridge(c).Theoverlay
supplyrollcangoononlyone
wayandonlyfitsonthecorrect
spindle.
B. Puttheemptysilvertake‐up
spoolonthesilvertake‐up
spindle(d).
C. Turnthetake‐upspool
clockwisetoremoveslackfrom
thematerial(e).Theoverlay
materialloadsinanS‐shape.
Makesurethattheoverlay
materialisbetweentheguideson
boththetake‐upandsupplysides
ofthecartridge.
6. Closethelaminatorcartridgegate(f).
Pushitinuntilthelatchclicksin
place (g).Makesurethattheoverlay
materialisnotpinchedbythe
cartridgegate.
7. Replacetheloadedlaminator
cartridgeintheprinter.
8. RemovetheL2(orange)cartridgefromthelaminator,ifinstalled.
9. Repeatsteps3through7toloadtheoverlayontothecartridge.
10. Closethelaminatordoor.