DataCard SD460 Installation And Administrator's Guide

70 Printer Manager
 ExceptionCardImpressTemperature—Set the temperature of the impresser punch (in
degrees Celsius).
 Increase the value to increase the temperature of the impresser punch.
 Decrease the value to decrease the temperature of the impresser punch.
 ExceptionCardNumberOfImpresses—Enter the number of impressions to be stamped on the
card. The impresser can stamp up to three impressions in a row on the left, center, or right
part of the card.
 HeaterMinutesToPowerSave—Set the number of minutes before the laminator and
impresser heaters are turned off. After the specified number of minutes, the heaters are
allowed to cool down. Using power save requires a warm-up period before the laminator is
ready to laminate cards again. The front panel LCD displays the message Busy Warming up
and a percentage that indicates the status of the heaters.
Hopper 1 Settings
Use the following settings to specify values for cards picked from the input hopper. Set up the
input hopper for the most commonly used card type.
Hopper 1 Debow Settings:
 Hopper1DebowDirection—Set the direction of the debow action in the laminator to return
the card to its proper shape after an overlay is applied. A card may become bowed slightly
due to heat from the laminator.
 Down—The debow arms in the laminator press down on the card.
 Up—The debow arms press up on the card.
 Hopper1DebowDistanceDown—Set the amount (distance) to move the debow arms down.
The value is in increments of the debow motor. (This value is used when
Hopper1DebowDirection is set to Down.)
 Increase the value to bend the card down more.
 Decrease the value to bend the card down less.
 Hopper1DebowDistanceUp—Set the amount (distance) to move the debow arms up. The
value is in increments of the debow motor. (This value is used when
Hopper1DebowDirection is set to Up.)
 Increase the value to bend the card up more.
 Decrease the value to bend the card up less.

DataCard SD460 Specifications

General

Color	Yes
Card size	85.6 x 53.98 mm
Card types	Magnetic stripe (ISO 7811), PVC, Smart card
Print technology	Dye-sublimation/Resin Thermal transfer
Duplex print speed (color)	200 card/h
Display	LCD
Certification	cULus, FCC, I.C., CE, Ctick, VCCI, RoHS, WEEE, CCC, KCC
Product color	Black, Blue
Internal memory	128 MB
Built-in barcodes	1D, 2D
Total input capacity	100 sheets
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Wi-Fi	No
USB version	2.0
Ethernet interface type	Fast Ethernet
Storage temperature (T-T)	-15 - 60 °C
Operating temperature (T-T)	15 - 35 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Weight	13600 g
Dimensions (WxDxH)	589 x 270 x 513 mm