DataCard SR300 - Site and Usage Guidelines; Operating Environment

B-2 Site Requirements and Specifications
Site and Usage Guidelines
Whenchoosingasitefortheprinteranditssupplies,considertheseguidelines:
 Keepalldust,dirt,food,liquids,etc.awa yfromtheprinteratalltimes.
 Keeppaperandforeignmaterialsofftheprinter.
 Placetheprinteronastableplatform;keepitoffthefloor.
 Donotplaceinareassusceptibletostrongvibrationorshock.
 Placetheprinterawayfromdirectsunlight.
 Placetheprinterawayfromheatingducts,blowers,orotherairvents.
 Donotusetheprinterforpurposesotherthanitsintendeduse.
 Whencleaningaroundtheprinter,preventdebrisfromenteringtheprinter.
 Placetheprinterinacleanofficeenvironment,protectedfromanytypeofconstruction.
 Storeallsuppliesintheoriginalpackaginguntilyouloadthemintheprinter.Keepthe
originalpackagingclosed.
 Storeallsuppliesinaclean,cool,anddrylocation.
 Donotusesuppliesorcardsthathavebeendroppedonthefloororhaveotherwisebecome
contaminated.
 Keeptheprinterpoweredoffandcoveredwhennotinuse.
Operating Environment
Theperformanceoftheprinterandlaminatorisstronglyinfluencedbytheinstallationlocation.
Usingtheprinterinarea sthatarecoolerthantherecommendedtemperaturescancause
retransfererrors.Usingtheprinterinareasthatarewarmerthantherecommended
temperaturescancauseerrorssuchascardwarpingandretransfer
filmerrors.
Considerthefollowingrecommendationsifyouneedtomoveorrelocateyourprinter.
 Temperature:59°–86°F(15°–30°C),or63°–83°F(17°–28°C)ifusingpeel‐off(PO)orUVink.
 Relativehumidity:35%–70%,non‐condensing,or35%–60%ifusingpeel‐offorUVink.