DataCard SR300

42 Printer and Laminator Settings
Printer Setting Tab
ThePrinterSettingtabdisplays:
 Controlsforviewingorchangingprintsettings:
 YMCInkPrintLevel.Setstheprintdensityforcolor
printing.Selectfromsevengradationsfrom‐3
(lighter)to+3(darker).
 ResinKInkPrintLevel.SetstheKresininkprint
density.Selectfromsevengradationsfrom‐3(lighter)
to+3(darker).
 UVInkPrintLevel.Selectfromsevengradationsfrom
‐3(lighter)to+3(darker).
 PeelOffInkPrintLevel.Selectfromsevengradationsfrom‐3(lighter)to+3(darker).
 ResinKInkPrintMode.SetstheKresininkprintquality.IfFineisselected,theprint
qualityimprovesbuttheprintingspeedisslower.ChangetoFineif thinlinesorsmall
blacktextisblurredonthecards.
 MGPeelMode.SelectMGStripefortheprintertousepeeloffribboninthemagnetic
stripearea(ifinstalled).
 StandbyMode.Pausesthecardafterprintingandbeforetransferringthecardtothe
laminator.
 BackSideCooling.SelectEnabletocoolthecardwhenprintingonbothsidesofthecard.
 Controlsforviewingorchangingmagneticstripesettings:
 NumberofRetry .Setsthemaximumnumberofretrieswhenwritingorreadingmagnetic
stripedatafails.Defaultvalueis1.
 ISOMode.Setsthepowerusedbythemagneticcardencoder.ThedefaultisHi‐Co.
 JISMode.Setsthepowerusedbythemagneticcardencoder.ThedefaultisHi‐Co.
 Controlstosetpowersavingcapabilities:
 PowerSavingInterval:Selecttheintervaltowaituntilpowersavingtakeseff ectandthe
printergoestosleep.SelectOfffornetworkoperationorselectfrom5to60minutesfor
aUSBconnection.ThedefaultisOff.
 HRControl:SelectEnabletolowerthetemperatureoftheretransferheatrollerwhen
printingisnotperformedfor30minutesorlonger.Whenenabled,heatroller
Whentheprintergoesintopowersavemode,SleepingdisplaysontheLCDpanel.
Tocancelpowersavemode,pressResetandthenthe(Return)key.