DataCard SR300

SR200 & SR300 Card Printers and LM200 & LM300 Laminators Users Guide B-3
Ventilation Clearance
Tomakesurethatthereisproperventilationfortheprinterandlaminator,maintainminimum
clearancedistancesasdescribedbelow.
 Sides:8inches(200mm)
 Back:4inches(100mm)
Storage Environment for Supplies
Followtheseguidelineswhenstoringribbon,fi lm,orlaminaterolls:
 Storesuppliesintheiroriginalpackaginguntilyouarereadytousethem.
 Selectalocationawayfromdirectsunlight,withatemperaturebetween41°Fand77°F(5°C
and25°C)withamaximumof40%–60%relativehumidity.
 Donotstoresuppliesindirectsunlightorhighhumiditylocations.
 Theprintribbonmaintainsitsqualityforaboutoneyear.Foroptimalcardquality,purchase
andstorequantitiesthatyoucanuseupinlessthanayear.
 Theprintribbonandcardstockmightrequiresecurestorageandtracking.Followyourpolicy
forstoringandtrackingthesuppliesusedtomakecards.
 Supplyrollsmustbeatroomtemperaturewhentheyareinstalledintheprinterandused.If
suppliesarestoredinacoolerenvironmentthantheprinter,allowsuppliestoreachroom
temperaturebeforeusing.
 Iftheprinterwillnotbeusedforanextendedperiodoftime,removesuppliesfromthe
printerandstorethem.