DataCard SR300

44 Printer and Laminator Settings
 Printsamplecardstoverifysettingsbeforeusingnewsettings.
Bend Remedy Tab
Single‐sidedprintingcancausecardstowarp,dependingon
thetypeofcardyouuse.Theprinterisavailablewithabend
remedyoption.
TheBendRemedytabisenabledonlyifthebendremedy
optionisinstalled.Itdisplaysthe:
 Matrixforsettingthebendremedyspeedand
temperature.Clickasquaretoselectthesetting.Orclick
Disabletopreventbendremedyfrombeingapplied.
 CardType(read‐only).UsetheMediaSettingtab
(page 44)tospecifythecardtypebeingused.
TipsforSuccess
 TheCardTypeisblankifthebendbemedyoptionisnotinstalledintheprinter.
 Bendremedyiseffectiveforsingle‐sideprinting.Fordouble‐sidedprinting,selecttheDisable
option.
 IfyouselectDisableandthebendremedyoptionisinstalled,theprintergoesintoPreheat
stateforabout10minuteswhiletherollertemperaturedrops.Waituntiltheprinterstatus
changestoReadybeforeprinting.
 Ifbendremedyisperformed,theprintedcardmayhaveamattefinish,ratherthanasmooth
finish.
 Printsamplecardstoverifyresultsbeforeusingthenewbendremedysettings.
Media Setting Tab
TheMediaSettingtabdisplaysthetypeofinkribboninthe
printer,thelotnumberoftheribbon,andthenumberof
panelsetsincludedintheribbon.Theprinterprovidesthis
informationanditcannotbechanged.
TheMediaSettingtabalsoallowsyoutosetthetypeand
thicknessofcardandthetypeofretransferfilmbeingusedin
theprinter.