DataCard SR300

56 Printer and Laminator Settings
Media InkType
 YMCK
 YMCK‐PO
 YMCKK
 YMCK‐UV
Displaysthetypesofinkribbonandretransferfilmthat
areloadedintheprinter.PresstheNextkeytoscrollto
thenextmediatype.
DatacardsupportsYMCK,YMCKKandYMCK‐POink
ribbons.(Theprinterdetectsthetypeofinkribbon;it
cannotbeset.)Consultwithyour
dealeraboutsupport
forYMCKUVinkribbon.
FilmType
 1000
Datacardretransferfilmisavailablewith1000frames
perroll.
CardThickness
 Standard
 Thin
DisplaysthethicknesssetusingtheStatusMonitor.
SelectStandardfor0.030inch(0.75mm)thickcardsor
Thinfor0.010inch(0.25mm)thickcards.Setthecard
hopperforthisthicknessalso.Referto“AdjustingCard
Thickness”onpage 14.
Contactyourdealerorserviceproviderbeforeusing
0.010
inch(0.25mm)thickcards.
Print YMCLevel
BlackLevel
BlackMode
UVLevel
POLevel
DisplaysthevaluesetusingtheStatusMonitor.
Retransfer TempLevel
Speed(front)
Speed(F‐UV)
Speed(back)
Speed(B‐UV)
MGPeelMode
StandbyMode
FrontWait
BackWait
BacksideCool
 On
 Off
DisplaysthevaluesetusingtheStatusMonitor.
MenuDisplay Settings Function