DataCard SR300

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 67
8. TheMode(Back)menudisplaysnext.Toapplyanadditional
retransferlayertothebackofthecard,pressChange.
9. Pre ssthedownarrowkeyoncetochangeLine2toOnandthen
presstoacceptthechange.
Thesuccessoftheretransf ercanvarydependingonthecard
materialused.Youmayneedtoadjustthefrontandbackspeedof
retransfertogetanacceptablecard.
Loweringthespeedcanenhancetheretransfer,butthestrongerheatthatresultsmaycause
thecardtowarp.Increaseor
decreasethespeedvalues,asneeded,todeterminethebest
retransferresultsforyourcardtype.
 Tochangethespeedvalues,continuewithstep 10.
 Ifyoudonotwanttochangethespeedvalues,gotostep 16.
10. Pre ssNexttocontinue.
11. TheSpeed(Front)menudisplaysnext.Tochangethefrontspeed,
pressChange.
12. Pre ssthedownarrowtochangethespeedandthenpressto
acceptthechange.
13. Pre ssNexttocontinue.
14. TheSpeed(Back)menudisplays.Tochangethebackspeed,press
Change.
15. Pre ssthedownarrowtochangethespeedandthenpressto
acceptthechange.
16. Pre ssExitthreetimestoreturntheprintertoReadystatus.
17. Printseveraltestcardstotestyoursettingsandverifythatthe
retransferfilmisbeingappliedproperly. Continuetoadjustthe
settingsuntilyouaresatisfiedwithyourcards.