Elrepho 3000
To view an existing task, follow steps 1 and 2 on the previous page,
then use the arrow keys to move through the list of existing tasks,
then press SEL to enter the Task View Moe when the task you want
to view is highlighted.
When in this mode, the following soft key labels will be displayed:
PRINT DEL EDIT EXIT
PRINT Prints the task setup information
DEL Deletes the task. (press twice to delete) Not
available if the task is used by a procedure.
EDIT Enters the Task Setup Mode. Refer to the next
section (not available if used by a procedure)
EXIT Exits the Task View Mode
Data Maintenance Mode
Task Maintenance Mode (cont)
Task Setup Mode
Use this mode to create a new task or edit an existing task.
Tasks that are currently in use by a procedure cannot be edited.
This screen will display the following data:
• Formula Type (Index, Colorimetric, Paper Task)
• Task Name
Datacolor International
23
To Next Page
Loading...
Need help?
General
