Elrepho 3000
12 Datacolor International
5. Read the Diagnostic Tile ( See User Diagnostics)
Once the instrument has been set up to conform to your operating
nvironment, a e job can be defined, and measurements can be made
nd displayed. a
Calibration
Instrument Calibration Mode
ay
set up by selecting the CALIB SETUP
option in the Setup Mode.
This is accessed by selecting the CALIB soft key from the Displ
Mode (see the Quick Start section). This is where you perform
routine calibration of the instrument using a black trap and user
selected white calibration standard. The parameters for the white
alibration standard can bec
To Next Page
Loading...
Need help?
General
