Elrepho 3000
Error Messages
Refer to this section if any error/status messages are displayed while using
the Elrepho 3000 series instruments.
NO JOB SELECTED
Displayed when the instrument is first turned on. This indicates
that no job has been selected as the current job. The current job
may be selected while in the Display Mode by pressing the soft key
labeled JOB and then selecting the desired job from the list of
existing jobs.
MEAS COND NOT CALIBRATED
Displayed whenever a measurement is requested using a
measurement condition which is not calibrated. Either select a
Datacolor International
53
To Next Page
Loading...
Need help?
General
