Elrepho 3000
The Elrepho 3000 supports three tests to verify that your instrument
is working properly.
• The drift test is used to verify the short-term stability of the
instrument.
• The diagnostic tile test is used to verify that the instrument's
measuring characteristics haven't changed significantly from the
time that it was installed.
• The Reflectance/XYZ test allows you to measure a sample and
display or print results without having to specify a job.
We suggest that you perform the first two tests weekly.
Drift Test
This test uses values you define to determine the number of
measurements to perform and the time between measurements.
The first measurement is used as the reference value.
The test displays X, Y,Z and DE data for measurements performed
during the test.
To perform this test:
1. Press SEL to select the Drift test from the Setup menu.
2. Press SETUP to specify the frequency and number of reads,
read time, viewing area and UV filter.
3. Press the MENU key to save these parameters.
4. Position your sample and press RUN.
User Diagnostics
Datacolor International
43
To Next Page
Loading...
