Elrepho 3000
This is used for the setup of communications parameters. Both the
keyboard and the printer will operate on the same serial port,
therefore, all settings are the same for both devices.
These settings include:
• Baud Rate
• Number of Data Bits
• Number of Stop Bits
• Parity Type
• Carriage Return Delay (printer only)
• Auto Line Feed Setting (printer only)
The Carriage Return Delay Setting is the amount of time the
instrument waits between sending each line of data.
The Auto Line Feed determines whether both a carriage return and
a line feed should be sent (enabled) or just a carriage return
(disabled).
OTE: Press MENU key to abort any changes and return to
return to
th
N
e System Setup Mode.
Datacolor International
39
To Next Page
Loading...
