Elrepho 3000
MEAS HOST SETUP CALIB
PRINT Prints data for the displayed screen. Depending
on the print mode settings for the job, either the
task data currently displayed will be printed, or
the task data for all tasks in the job will be
printed.
SAVE Saves data from the Measurement Mode which
has not yet been saved.
Display Mode
-TSK Displays the measurement data for the previous
task in the job’s procedure.
+TSK Displays the measurement data for the next task
in the job’s procedure.
MEAS Enters the Measurement Mode (can also press
the Measure Button). Refer to the Measurement
Mode section for details.
JOB Enters Job Selection or Change Job Mode, which
allows the creation of a new job, or selection of
Datacolor International 9
To Next Page
Loading...
