D-500L Firmware V-5.8
K35D03-EN - 100 -
The parameters below define the functions of relay outputs. The unit has 8 relay outputs. All relays have
programmable functions, selected from a list.
Relays may be extended up to 40 using Relay Extension Modules.. Other relays are in the optional
Extension Modules.
Factory set as Crank Relay output
Factory set as Fuel Relay output
Factory set as Horn Relay output
Factory set as Preheat Relay output
Factory set as Stop Relay output
Factory set as Idle Speed Relay output
Factory set as Mains Contactor Relay output
Factory set as Genset Contactor Relay output
Relay extension module – 1
Relay extension module – 1
Relay extension module – 1
Relay extension module – 1
Relay extension module – 1
Relay extension module – 1
Relay extension module – 1
Relay extension module – 1
Relay extension module – 2
Relay extension module – 2
Relay extension module – 2
Relay extension module - 2
Relay extension module - 2
Relay extension module - 2
Relay extension module - 2
Relay extension module - 2
Relay extension module - 3
Relay extension module - 3
Relay extension module - 3
Relay extension module - 3
Relay extension module - 3
Relay extension module - 3
Relay extension module - 3
Relay extension module - 3
Relay extension module - 4
Relay extension module - 4
Relay extension module - 4
Relay extension module - 4
Relay extension module - 4
Relay extension module - 4
Relay extension module - 4
Relay extension module - 4
Below is a short list for reference purposes. Please use
the RainbowPlus program for complete selection list.
16.9. OUTPUT CONFIGURATION
To Next Page
Loading...
Need help?
General
