D-500L Firmware V-5.8
K35D03-EN - 104 -
These parameters accept both internet addresses (like
http://datakom.com.tr) and IPv4 addresses (like
78.192.238.116). Information for remote monitoring is
sent to these addresses.
The port information of these addresses are found in
Controller Configuration group.
This is the account name appearing in the “from” tab
of the e-mail recipient. (ex: datakom-d500@gmail.com)
This is the e-mail password of above e-mail account.
This is the Outgoing Mail Server Address of the above
e-mail account (ex: smtp.gmail.com)
E-mail Address-2
E-mail Address-3
These are e-mail recipient addresses where the unit is
intended to send e-mail messages. Up to 3 e-mails can
be sent at once.
The unit will update the distant
monitoring terminal with this rate.
This is the port number of the first
monitoring terminal address.
This is the port number of the second
monitoring terminal address.
This is the port number used for e-mail
sending.
This parameter controls e-mail sending
when IP address of GPRS connection is
changed. No warnings generated.
0: no e-mail on IP change
1: e-mail sent on IP change
Below ETHERNET related parameters are found in the
Controller Configuration group.
16.14. ETHERNET PARAMETERS
To Next Page
Loading...
Need help?
General
