Datakom D Series User Manual

D-500L Firmware V-5.8
K35D03-EN - 48 -
BUTTON
FUNCTION
Selects TEST mode. The genset runs and takes the load.
Selects RUN mode. The genset runs off-load.
Selects AUTO mode. The genset runs when necessary and takes the load.
Selects OFF mode. The genset stops.
Selects next display screen in the same display group.
LAMP TEST when held pressed.
Selects previous display group.
Selects next display group.
Selects previous display screen in the same display group.
Resets the ALARM RELAY.
Manual MAINS CONTACTOR control in RUN mode.
Manual GENSET CONTACTOR control in RUN mode.
When held pressed for 5 seconds, enters PROGRAMMING mode.
Makes factory reset. Please review chapter RESETTING TO FACTORY
DEGAULTS for more details.
When held pressed for 5 seconds, resets service request counters. Please review
chapter SERVICE REQUEST ALARM for more details.
9.2. PUSHBUTTON FUNCTIONS

Datakom D Series Specifications

General

Brand	Datakom
Model	D Series
Category	Controller
Language	English