EasyManuals Logo

Datakom D Series User Manual

Datakom D Series
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
D-500L Firmware V-5.8
K35D03-EN - 103 -
Parameter Definition
Description
APN User Name
The APN (access point name) username may be required by the GSM
operator. However some GSM operators may allow access without
username.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
APN Password
If the APN (access point name) username is required by the GSM
operator, most probably the APN password will also be required. However
some GSM operators may allow access without password.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
APN Name
The APN (access point name) is always required by the GSM operator.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
SMS Service Center
Number
The SMS service center number may be required by the GSM operator.
However some GSM operators may allow SMS sending without SMS
service center number.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “sms service center” string.
Parameter Definition
Unit
Min
Max
Factory
Set
Description
GSM Sim Card Pin
-
0000
9999
0
If the GSM SIM card uses pin number,
enter the pin number here. If incorrect
pin number is entered, then the SIM
card will not operate.
SMS Enable
-
0
1
0
0: SMS messages disabled
1: SMS messages enabled
GPRS Connection
Enable
-
0
1
0
0: GPRS disabled
1: GPRS enabled
SMS on Mains Change
-
0
1
0
This parameter controls SMS
sending when mains voltages status
is changed. No warnings generated.
0: no SMS on mains failed or
restored
1: SMS sent on mains failed or
restored
SMS on IP Change
-
0
1
0
This parameter controls SMS
sending when IP address of GPRS
connection is changed. No warnings
generated.
0: no SMS on IP change
1: SMS sent on IP change
Below GSM modem related parameters are found in the
Controller Configuration group.
16.13. GSM MODEM PARAMETERS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datakom D Series and is the answer not in the manual?

Datakom D Series Specifications

General IconGeneral
BrandDatakom
ModelD Series
CategoryController
LanguageEnglish

Related product manuals