Datakom D Series User Manual

D-500L Firmware V-5.8
K35D03-EN - 93 -
Parameter Definition
Unit
Min
Max
Factory
Set
Description
J1939 Speed Adjust
%
-100
+100
0.0
This parameter adjusts the speed of an
ECU controlled engine by +/- 8%.
High Air Inlet
Temperature Warning
Limit
°C
0
200
0
If the air inlet temperature measured
through ECU is over this limit, then a
high air inlet temperature warning will
occur.
High Air Inlet
Temperature Alarm Limit
°C
0
200
0
If the air inlet temperature measured
through ECU is over this limit, then a
high air inlet temperature
shutdown/loaddump alarm will occur.
High Air Inlet
Temperature Alarm
Action
-
0
1
0: shutdown alarm
1: loaddump alarm
Low Coolant Level
Warning Limit
%
0
100
0
If the coolant level measured through
ECU is below this limit, then a low
coolant level warning will occur.
Low Coolant Level Alarm
Limit
%
0
100
0
If the coolant level measured through
ECU is below this limit, then a low
coolant level shutdown/loaddump alarm
will occur.
Low Coolant Level Alarm
Action
-
0
1
0
0: shutdown alarm
1: loaddump alarm
Battery Charge Run
Voltage
V-DC
0
35.0
0
If the battery voltage goes below this
limit the engine will be automatically
started in order to charge the battery
using the charge alternator.
Battery Charge Run
Timer
min
0
1200
0
If the battery voltage goes below the
Battery Charge Run Voltage limit, the
engine will be automatically run during
this period in order to charge the
battery using the charge alternator.
Oil Pump Stop Pressure
bars
0
20
0
The oil pump is activated prior to the
crank cycle and stopped when this
pressure level is reached.
If this value is set to zero, then the oil
pump is not activated.
Service Reset-1
-
0
1
0
0: no action
1: reset service-1 counters
Service Reset-2
-
0
1
0
0: no action
1: reset service-3 counters
Service Reset-3
-
0
1
0
0: no action
1: reset service-3 counters
Disable ECU speed
control
-
0
1
0
0: Engine speeed checking is
performed with the RPM information
coming from the engine ECU unit.
1: the RPM information coming from
the engine ECU unit is not used for
engine speed checking.
J1939 SPN Mask
-
0
65535
0
The SPN number written to this
parameter is excuded from engine
ECU alarm list.
J1939 FMI Mask
-
0
65535
0
The FMI number written to this
parameter is excuded from engine
ECU alarm list
16.3. ENGINE PARAMETERS GROUP (continued)

Datakom D Series Specifications

General

Brand	Datakom
Model	D Series
Category	Controller
Language	English